Lil’ Clucker Large Automatic Filling Poultry Waterer Cups (4 Pack) and Leg Bands (20 Purple Color) | Auto Watering Drinker System for Chickens, Ducks, Geese, Turkeys etc. | Water Feeder Kit

September 20, 2019 - Comment

INCLUDES: 4 Large Automatic Filling Water Feeder Cups 20 Leg Bands (3/4″) Assorted Colours Our cups refill automatically when the water level gets low to ensure a constant supply of clean, fresh water is provided to your flock. The leg bands easily clip around the leg of your bird making identification easy even from across

Buy Now! $16.49Amazon.com Price
(as of October 8, 2019 9:17 am GMT+0000 - Details)

INCLUDES:

4 Large Automatic Filling Water Feeder Cups

20 Leg Bands (3/4″) Assorted Colours

Our cups refill automatically when the water level gets low to ensure a constant supply of clean, fresh water is provided to your flock. The leg bands easily clip around the leg of your bird making identification easy even from across the yard.

CONTAINER INSTALLATION INSTRUCTIONS 

Step 1. Using a 3/8″ drill bit, drill a hole in the side of the container for each cup. 

Step 2. Remove any burrs or debris from around each drill hole. 

Step 3. Remove wingnut and insert cup assembly into the hole until the rubber washer contacts the outside of the container.

Step 4. Hold the cup in place ensure the correct position while screwing the wingnut onto the thread inside the bucket and tighten by hand.

Step 5. Thoroughly wash out the container after installation, to ensure that it is free of all residual debris. Dirt and plastic shavings may cause water cups to stop functioning correctly.

Step 6. Find a location to place or hang the container so the cups are at a suitable height for your birds

LOW PRESSURE PVC PIPE INSTALLATION INSTRUCTIONS (Requires 1/8″ NPT Tee Fitting)

Step 1. Remove wingnut from cup assembly.

Step 2. Screw cup into 1/8″ NPT Fitting.

Comments

Write a comment

*

amzzn_assoc_linkid = "4a1c380f2aa5323535fc94a03ca4ac27"; amzn_assoc_placement = ""; amzn_assoc_marketplace = "amazon"; amzn_assoc_region = "US";